selfbus.org

Florian, very nice build!

Can you tell/show something regarding ETS5 integration of the device?
I'm interested in 2 sets of circuit boards as well, do you have any spare 3D printed parts too?

I wondered myself for weeks where to get them. Until I noticed that the are the standard KNX connectors plugged onto a WAGO pin soldered on the board. :-)) http://www.myknxstore.co.uk/wiring-accessories-c51/abb-bus-connection-terminal-red-black-p1143 https://www.reichelt.de/Stiftleisten/WAGO-243-131...

I wonder where to get the red/black KNX bus connectors used in for example the Eingangsmodul ARM?

Yes I did.
The program runned fine could program it with ets and all but the io ports didn't work.
Did you experienced something siilar?

I will try again this weekend, bit already tried is a few times with that chip.
The current one still works ok and reports all 4 temps correctly.

Some new LPC chips came in, I reprogrammed and replaced the one on my TS-DIL module, and all ports work now, I had a faulty chip! :oops: The values are also correct now: 2014/11/07 18:42:57 [KNX] Received packet from physical device with address '1.1.10' to '1/4/1' 2014/11/07 18:42:57 [KNX] Processe...

Some more testing... I reloaded my 4temp module with exact (german) vd1 file as linked to on 4temp wiki page, doesn't change anything. I ordered ds18s20's and thats written on the package there were in, but not written on the sensors themselves only "ds1820", replaced the one at IO3 for an...

Wire lengths are 30cm's it's still on the workbench/test lab.

I have connected them as described in the schematic attached. I flashed the 4temp v2.02 hex without watchdog enabled, although there is watchdog related code found in source, it reboots every x secs when enabled, so disabled it. Programming works, I see the group addresses coming in, but with static...

Or should I use?
https://github.com/selfbus/software-inc ... ter/4sense

https://github.com/selfbus/software/blob/master/4temp/Releases/4temp_V2_02.hex Should this firmware work already for 4 DS18S20's directly connected to P0_0 P0_1 P0_2 and P0_3 of an LPC on a TS-DIL module? I have flashed it, and configured it in ETS4, this went OK. (selected 0..5V for 18S20) It write...