selfbus.org

apparently every ARM device creates problems 2in-2out (only this apparently only in programming physical addresses). In fact I istalllato an ARM binary actuator 8 channels and an ARM blind actuator, which give the same problem. I'm using the library taken at "https://github.com/selfbus/software...

try ne version again with option 'erease all' I thought the version 1.0b was the last! Where do I find the "true" last? I noticed, however, that the presence of an ARM device bus as IN16-bim112 prevents programming the physical address of "2in-2out" with 1.0b firmware. In fact, ...

Hello I'm back to you with another question. Some time ago I built a 2in-2out actuator with satisfaction, but then I noticed that the firmware version 1.0 does not allow food to standard relay directly from the bus 24v (excessive consumption 30mA with two active relays), then I switched to version 1...

thank you

hi, I have positively changed the firmware for ARM " IN16 - bim112 " to have only 4 channels ( ch1..ch4 ) and with 4 LEDs for feedback on what were ch5..ch8 channels . Now I would like to modify the firmware to fit the application file vd BE- 040xx.01 but the firmware is not clear whether ...

the varistor is in c.c. ,no recoverable information
Obviously the feeder work fine without varistor , but is without protection !

oldcoolman hat geschrieben:was it rearly a varistor, not a TVS Diode 36V ?

yes, is a varistor (pcb label = VR2)

Hello
Lightning has damaged my system KNX power supply .
Fortunately, the damage is limited to the final varistor that has no code and is the SMD type .
I thought I would replace it with the 82541250 pattern of Würth Elektronik .
The model is correct ?

thank you

So did you change anything? Or did you simply convert my .axf to .hex and it worked? Good morning I confirm the operation of my Hex (evidently it was just a problem with the conversion from AXF -> HEX). Out of curiosity, do you work the PWM? why not me !. Probably 'it disabled. But it is essential....

by the time I converted your file.
Try 'then convert my. (I followed your steps but initially I did not understand that I had to use the "arm-none-eabi-objcopy" in DOS, I did it directly LPCExpresso.

thanks again.