I'm trying to send messages from Gira HS to Raspberry PI with EIBD to the KNX bus.
Actually I've tried the image from Selfbus wiki and I'm correctly connecting with ETS3 through KNXNET/IP. But unfortunately with HS don't receive any message.
If i do: eibd --trace=5 --listen-local ip:
Then I can see the messages from Gira HS each time I push a button, but the doubt is, how I pass the messages from IP to the bus?
The device is connected though raspberry pi serial port /dev/ttyAMA0
I can see the telegram from HS when click to a button on quadclient while logged on the raspberry and put in the console the command:
#eibd --trace=5 --listen-local ip:
But no retransmission to /dev/ttyAMA0
By the way, I've formatted the card and now I'm installing plain EIBD (no knxweb) and try again to see if it works.
My raspi local ip is:
192.168.1.158 and i've added
#sudo route add 220.127.116.11 dev eth0
The homeserver EIB Connection config is:
Physical Address: 0.0.254
Ip Routing Multicast: 18.104.22.168
I will tell my results..
I don't know if this is bad or good news, I've wipped entire raspberry pi SD card and started again, installing only EIBD.
For helping other people I've included my steps to get it working starting from fresh raspbian install (click on Spoiler to show):
Now my problem... I'm starting EIBD with
Code: Alles auswählen
#eibd -t 1023 -i -D -T -S --eibaddr=0.0.254 ft12:/dev/ttyAMA0
So appears to see the messages flowing both directions (from KNX bus and from HS). But can't make the light to work. I'm doing some more tests but maybe someone has it working? Probably I'm starting eibd with the wrong commands?